ΚΑΛΑΘΙ ΑΓΟΡΩΝ
Το καλάθι σας είναι άδειο
Spinner
contact-phone
ΤΗΛΕΦΩΝΙΚΟ ΚΕΝΤΡΟ
+30 261 500 2002

TOP ΕΤΑΙΡΕΙΕΣ

ΟΛΕΣ ΟΙ ΕΤΑΙΡΕΙΕΣ

Η Telematica είναι αποκλειστικός αντιπρόσωπος των κορυφαίων εταιρειών μηχανοκίνητου αθλητισμού και ηλεκτρονικών. Περιηγηθείτε στην ευρεία γκάμα κατασκευαστών μας και εξοπλίστε το όχημά σας με προϊόντα υψηλής ποιότητας και απόδοσης.

ΔΕΙΤΕ ΟΛΕΣ ΤΙΣ ΕΤΑΙΡΕΙΕΣ
  • CloseMENU

Charging System Kit for EVO Softail and Dyna Big Twins

32 Amp Alternator

ACCEL Performance
Κατασκευαστής : ACCEL Performance
Κωδικός : 152300
Barcode : 743047106280
ERP Code : ACC-0683

What better way to insure plenty of juice when you need it than to install a complete ACCEL Motorcycle 32 amp charging system featuring the top quality ACCEL components and our famous lifetime replacement warranty. Matched components ensure reliability, plus the ease of only ordering one part number! Charging System, 32 Amp, Excludes Twin Cam, Kit.

13.UPS
Official ACCEL Performance Distributor
Supplier Warranty
* Εντοπίστε το πακέτο σας οποιαδήποτε στιγμή μέσω του tracking number που θα σας στείλουμε μέσω SMS και e-mail

Πληροφοριες προιοντος

Charging Problems

Check the Stator:

  1. Disconnect the regulator from the stator at the terminal inside the crankcase.
  2. Check for continuity between either stator pin and the crankcase. Continuity indicates that the stator is grounded and needs to be replaced.
  3. Check the resistance between the stator pins. A reading of 0.1 to 0.2 ohms should be present. A lower reading requires that the stator be replaced.

Check the Output:

  1. Again disconnect the regulator, and connect a voltmeter set to AC volts across the stator terminals. With the engine running at 2000 rpm, there should be a reading of 32-40 AC volts. The output will increase or decrease 16-20 AC volts for every 1000 rpm.

Check the Current Draw:

  1. With all accessories, ignition, and headlamp high beam turned on, read the current draw.
  2. The current draw should be at least 3.5 Amps lower than the output listed in the SPECIFICATIONS section of the Harley-Davidson service manual. You may have too many accessories drawing power for the system to handle.

How Do I Polarize My Generator?

  1. A generator that is not polarized will burn relay points, cause a dead battery, or damage to the generator.
  2. Momentarily touch a jumper wire between the BAT and GEN terminals on the generator.

Παρομοια προιοντα

ΕΠΙΚΟΙΝΩΝΙΑ
+30 261 500 2002
Call Center
Telematica Contact Email
Email Message
ΩΡΕΣ ΛΕΙΤΟΥΡΓΙΑΣ
Δευτέρα - Παρασκευή 9:00 - 20:00
Σάββατο - Κυριακή Κλειστά
W3C HTML5 validator